Optocoupler modules for rail mounting

OK1
Optocoupler output 24V / 200kHz

The optocoupler modules of the series OK1 are made for the galvanic isolation and / or amplification of digital signals with 5V TTL or 24V HTL to 500kHz. They are suitable for mounting on cap rail.

Datasheet

OK2
Optocoupler output 5V / 500kHz

The optocoupler modules of the series OK2 are made for the galvanic isolation and / or amplification of digital signals with 5V TTL or 24V HTL to 500kHz.

Datasheet

OK21
Optocoupler output 5V / 500kHz small control current <2mA

The optocoupler modules of the series OK21 are particularly suitable for isolating high-ohmic digital outputs. They only need a control current of < 2mA.

Datasheet

OK3
Optocoupler, power 24V / 3A; solid state relay

The power optocouplers of the series OK3 are made for the galvanic isolation and amplification of digital signals. They are suitable for direct controlling of ohmic- and inductive loads.

Datasheet

OK4
4-channel optocoupler, power 24V / 4 x 3A; solid state relay

The power optocouplers of the series OK4 are made for the galvanic isolation and amplification of digital signals. They are suitable for direct controlling of ohmic and inductive loads.

Datasheet

OK5
Optocoupler with transistor output

The devices of the optocoupler series OK5 provide the user with a free transistor output, which can be used as a NPN or PNP output. It is suitable for switching DC signals in the range of 0…250VDC with a maximum load of 100mA. Furthermore there is the possibility, by a suitable wiring, to create a „Wired-OR" linkage. The driving, depending on the device type, is operating with a DC voltage in the range 5 to 60V DC. It can be configured by the user with soldering jumpers in the module or can be ordered preconfigured from us by using our order code.

Datasheet

OK11
Optocoupler 24VDC – 500 kHz, input current: < 2mA

The devices of the optocouplers series OK11 have been developed for galvanic isolation resp. the amplification of TTL/HTL - signals. Because of the extremely low input current they are particularly suitable for driving by CMOS/TTL – outputs. Because of the push-pull output they are particularly suitable for the transmission of signals via long lines. One LED in output displays the switch status.

Datasheet

UG6
6-channel AND gate Auxilary power 24Vdc

The devices of the series UG6 have a 6-input AND gate, suitable for logical gates of up to 6 digital signals. Because of optocoupler in- and outputs a 3-way potential isolation is ensured.

Datasheet