Power supply, DC-DC converter |
|||
|
|||
NG5 / NG24
|
|||
|
The power supply series NG24 is designed to power our components. It is possible to power up to 10 of our modules. |
||
NG2
|
|||
|
The transformer power supply units of the series NG2 are completely analog built and linearly controlled. They are particularly suitable for the use in analog systems or circuits. Available are the units with a width of 45 mm with the following voltages: 5V / 600mA, +/-10V / 200mA, +/-12V / 200mA, +/-15V / 200mA, 24V / 300mA. |
||
DC1
|
|||
|
DC-DC-converter for rail mounting with voltage output of 5V / 1A, +-15V / 150 mA |
||
DC3
|
|||
|
The devices of the DC/DC – converters series DC3 have been developed especially for supplying our octocouplers of the series OK2 / OK21, they provide the necessary supply voltage for these units to the user. Support of any 5V, 10V and 12V load consumers from a 24VDC-power system. Input- and output voltage are based on the same ground, they are NOT, as usual with DC/DC – transformers, galvanic isolated. The units are developed as switching power supplies and therefore very low-loss. One LED in output displays the ONposition. |
||
DC4
|
|||
|
The units of the DC / DC converters series DC4, provided with a linear readjusted output voltage, are developed for the support of small consumers with a positive or negative output voltage. Via a spindle-operated potentiometer every polarity can be separately readjusted. One LED per output displays the ON-position. Easy mounting on snap-on norm rail TS35. |
By using this page you accept the data privacy statement of LEG Industrie-Elektronik GmbH |